礼堂椅是很多人共用的一种工具，平时会特别脏，这个情况要如何清理?下面礼堂椅厂家分享给大家

The auditorium chair is a lot of people Shared a tool, will be particularly dirty at ordinary times, how to clean up this situation? The following auditorium chair manufacturer to share with everyone

木质礼堂椅的清理有要求。木质材料的应避免饮料、化学药剂或过热的物体放置在表面，以免损伤木质表面的天然色泽；皮料吸收力强，应注意防污；皮革材料的应采用皮革专用清洗剂清洁，切忌用烈性清洁剂。

Wooden auditorium chair cleaning requirements. Woodiness material should avoid to drink, chemicals or overheating object placed on the surface, so as not to damage the surface of the wood natural color; Leather strong absorption, anti-fouling should be paid attention to; Leather material should be used for leather cleaner cleanness, avoid by all means use strong detergents.

金属质礼堂椅清洁有讲究。 金属材料的保养可使用柔软的抹布擦拭，但避免使用粗糙、有机溶剂(如松脂油、去污油)或湿的布块擦拭，这些都是造成表面伤痕、生锈的主要原因。经常用干棉丝或细布擦一擦，以保持光亮和美观。

Metal mass auditorium chair clean has exquisite. Metal materials and maintenance can use soft cloth to wipe, but avoid using rough, organic solvents, such as turpentine oil, decontamination oil) or wet cloth to wipe, these are the main reasons of surface scars, rust. Often with dry cotton silk or cloth to wipe clean, to keep them bright and beautiful.

。

.

1、软布擦干棉质礼堂椅，然后烘干。布面保养禁止使用湿布、硬物或酸、碱性等化学物品接触面料，以免影响表面质量和使用周期。若沾到饮料、果汁，可先用擦手纸巾吸去水分，然后以温水溶解中性洗洁剂擦拭，再使用干净的软布擦干，最后以低温烘干即可。

1, soft cloth to wipe dry cotton auditorium chair, and then drying. Cloth and maintenance it is prohibited to use wet cloth, or chemical contact fabrics such as acid, alkali, lest affect the surface quality and life cycle. If touch to drink, fruit juice, can use first hand paper towels absorb moisture, dissolved with warm water and neutral detergent to wipe, then use a clean soft cloth to wipe, finally the low temperature drying.

2、水擦布质礼堂椅，然后烘干。一般保养只须使用干净柔软的布料轻轻擦拭即可，如果要清理长期使用所产生的污垢，最理想的方式为：首先使用温水稀释的中性清洁剂先行擦拭，再以拧干的清水抹布擦去清洁液，最后再以干布擦亮，待全干后使用适量的保养剂均匀擦拭即可。

2, water wipe cloth auditorium chair, and then drying. General maintenance simply use a clean soft cloth to wipe gently, if you use for a long time to clean up the dirt, the best way is: the first use of neutral cleaner when diluted with warm water first to wipe, with dry clean dishcloth to clean liquid, again with dry cloth to polish finally, after waiting for all dry use proper maintenance agent can wipe evenly.

3、吸尘机适用于所有材料制作的礼堂椅。 背、扶手与座面交接处缝隙可用吸尘器清洁杂物。但在用吸尘器时，不要用吸刷，以防破坏纺织布上的织线而使布变得蓬松，更要避免以特大吸力来吸，此举可能导致织线被扯断，不妨考虑用小的吸尘器来清洁。

3, suction machine applies to all materials of the auditorium chairs. Back, armrest and seat aperture can use vacuum cleaner at the junction of clutter. But when using a vacuum cleaner, do not use brush, in case of damage of textile cloth woven wire cloth and made fleeciness, more to avoid extra large suction to suck, a move that could lead to knit line was broke, may wish to consider using a small vacuum cleaner to clean.

礼堂椅的优劣怎么辨别？

Identify the pros and cons of the auditorium chair?

证件法：正厂的皮革，均有清楚的来源，登载生产地，皮革厂标，皮革测试表，皮革使用授权书等基本资料，缺一不可。

Identification method: factory leather, all have clear source, published producer, tanneries and leather testing table, leather use basic information, such as the power of attorney, be short of one cannot.

卷标法:：正厂皮革，背面均会标示制造日期，皮厂名称面积等。(制造日期不宜过久，超过3年的皮革应注意有无发霉现象)。

Volume label method: : factory leather, will be marked on the back the manufacturing date, name of leather factory area, etc. (manufacturing date shoulds not be too long, more than three years of leather for the mould) should be paid attention to.

观看法：在30倍放大镜下，则可见到皮革外表有如月球表面，坑坑洞洞，其透气性佳。以刀片横切皮革，可见皮革由外表层至内里层颜色均须一致。注意外表层下方是否有异色产生，可避免买到染色或改色的二手皮革。

Watch law: under 30 x microscope, is visible to the leather looks like the surface of the moon, hole hole hole, its permeability is preferred. Visible in the blade cut leather, leather from outer layer to inner layer color must be consistent. Note below the outer layer is there a different color, can avoid to buy or breathing second-hand leather dyeing.

嗅觉法：良好的皮革，在处理后应该不会有刺鼻味道，所以太多的溶剂味及涂料味是不好的。

Smell method: good leather and should not have pungent smell after processing, so much of solvent odor and coating is not good.

耐热法：最好跟厂商要个小块的皮材，用香烟头触烫样品达2~3秒钟，可避免买到PU制品，用打火机燃烧因接触面积大，故时间需加长。

Heat resistant method: best with the manufacturer for a small piece of leather material, with cigarette butts touch hot samples up to 2 ~ 3 seconds, can avoid to buy PU products, burning with lighter due to the large contact area, so the time should be extended.

擦拭法：以去渍油擦拭皮革表层，注意有无褪色及脱落现象，可避免买到2次改色皮革。

Wipe method: to soiled oil is wiped the leather surface, pay attention to whether fade and fall off phenomenon, can avoid to buy two natural leather.